Polk Audio PA600.1

1200W Max, Class D Monoblock Amplifier

• PA Series Class D Monoblock Car Amplifier
• RMS Power Rating:
  • 4 ohms: 300 watts x 1 chan.
  • 2 ohms: 400 watts x 1 chan.
  • 1 ohm: 600 watts x 1 chan.
• Max power output: 1200 watts x 1 chan.
• PWM (Pulse Width Modulated) MOSFET power supply
• Wired remote volume level control included
• LED power and protection indicators
• Selectable bass boost (0, +8 dB at 40 Hz)
• Double-layer fiberglass epoxy printed circuit boards
• 1 ohm stable
• Master/Slave switch for easy daisy chaining of other amplifiers
• Master/Slave switch allows parallel operation- master amp’s gain and crossover settings will be duplicated in "slave" amplifiers for consistent, repeatable settings
• High-speed MOSFET switching power supply and high current Bipolar Output Transistors pump maximum voltage and high current to your subwoofers
• Connection for optional LED light bar or optional amplifier cooling
• Power/ground-reversal, thermal, short, current, overdraw, and low impedance protection circuitry
• Cast aluminum textured end caps
• Switchable 180° phase inversion
• Variable input sensitivity optimizes match with different signal sources
• Unity gain pass-through RCA jacks
• Mounting hardware with rubber isolation grommets and extra fuses included.
• Effective Damping Factor: >150
• Anodized extruded brushed-aluminum cover for maximum heat dissipation
• Preamp RCA outputs
• Chrome-plated RCA level inputs
• Chrome-plated screw terminals
• Variable low-pass filter (30-250 Hz, 12 dB/octave)
• Subsonic Filter (24 dB at variable frequencies)
• CEA-2006 compliant amplifier
• Frequency response: 20-250 Hz
• Dimensions: 13-3/4"L x 10-1/4"W x 2-3/4"H
• 4-gauge power and ground wiring is required for installation. Contact us for information regarding a discount on select amplifier kits when purchased together with this amplifier.

Написать отзыв

Ваше имя:

Ваш отзыв: Примечание: HTML разметка не поддерживается! Используйте обычный текст.

Оценка: Введите код, указанный на картинке: